modelSimpleHeatTransfer
Validation model to check the implementation of the simple heat transfer
Extends from Modelica.Icons.Example.
Information
This is a simple validation model to test the one-directional heat transfer. Therefore, an ambient temeprature is prediscribed and an expansion vassel is located at the model's outlet.
Parameters
| Type | Name | Default | Description |
|---|---|---|---|
| Modelica.Units.SI.AbsolutePressure | pInl | Medium.pressure(Medium.setBubbleState(Medium.setSat_T(TInl + 2))) | Current pressure at inlet conditions |
| Modelica.Units.SI.Temperature | TInl | 283.15 | Current temperature at inlet conditions |
| Modelica.Units.SI.AbsolutePressure | pOut | Medium.pressure(Medium.setDewState(Medium.setSat_T(TOut - 5))) | Current set point of the compressor's outlet pressure |
| Modelica.Units.SI.Temperature | TOut | 333.15 | Current temperature at outlet conditions |
Components
| Type | Name | Default | Description |
|---|---|---|---|
| Sources.MassFlowSource_T | source | Source of constant temperature and mass flow rate | |
| Modelica.Thermal.HeatTransfer.Sources.FixedTemperature | fixTem | Fixed ambient temperature | |
| Utilities.HeatTransfer.SimpleHeatTransfer | simheaTra | Model of simple one-dimensional heat transfer | |
| MixingVolumes.MixingVolume | sink | Sink that allows storage of mass and energy |
Contents
| Name | Description |
|---|---|
| Medium | Medium of the compressor |
Revisions
- October 30, 2017, by Mirko Engelpracht:
First implementation (see issue 467).