modelTemperatureControlledHeatFlow
Prescribed heat flow boundary condition, depending on a set temperature TSet
Information
This model allows a specified amount of heat flow rate to be "injected"
into a thermal system at a given port. The amount of heat
is given by the input signal T_set into the model. The heat flows into the
component to which the component PrescribedHeatFlow is connected,
if the input signal is positive.
Parameters
| Type | Name | Default | Description |
|---|
| Modelica.Units.SI.HeatFlowRate | Q_flow_maxHeat | | Maximum heat flow rate for heating (positive) |
| Modelica.Units.SI.HeatFlowRate | Q_flow_maxCool | | Maximum heat flow rate for cooling (negative) |
Components
| Type | Name | Default | Description |
|---|
| Modelica.Blocks.Interfaces.RealInput | TSet | | Set temperature of the heater |
| Modelica.Thermal.HeatTransfer.Interfaces.HeatPort_b | port | | |
| Medium.SpecificEnthalpy | h_outflow | | Specific thermodynamic enthalpy |
| Medium.MassFlowRate | m_flow | | Mass flow rate |
| Modelica.Units.SI.Pressure | p | | Pressure |
| Modelica.Units.SI.MassFraction[Medium.nXi] | Xi | | Mass fraction |
Contents
| Name | Description |
|---|
| Medium | Medium in the component |