| Boolean | useAverageTemperature (from DistributedHeatTransferFV) | true | = true to use average temperature for heat transfer |
| SI.Length | l (from DistributedHeatTransferFV) | L/(Nw) | Length of a single volume |
| Modelica.SIunits.PerUnit | kc (from DistributedHeatTransferFV) | 1 | Correction factor for heat transfer |
| SI.CoefficientOfHeatTransfer | gamma_nom (from FlowDependentHeatTransferCoefficient) | | Nominal heat transfer coefficient |
| SI.PerUnit | alpha (from FlowDependentHeatTransferCoefficient) | | Exponent in the flow-dependency law |
| SI.PerUnit | beta (from FlowDependentHeatTransferCoefficient) | 0.1 | Fraction of nominal flow rate below which the heat transfer is not reduced |
| SI.MassFlowRate | wnom_ht (from FlowDependentHeatTransferCoefficient) | wnom | Nominal flow rate for heat transfer correlation (single tube) |
| Boolean | adaptiveAverageTemperature (from FlowDependentHeatTransferCoefficient) | true | Adapt the average temperature at low flow rates |
| Modelica.SIunits.PerUnit | sigma (from FlowDependentHeatTransferCoefficient) | 0.1 | Fraction of nominal flow rate below which the heat transfer is computed on outlet volume temperatures |
| Boolean | useHomotopy (from FlowDependentHeatTransferCoefficient) | true | use nominal heat transfer coefficient for simplified model |
| SI.ThermalConductance | UAnom | | Nominal global thermal conductance (UA value), for Nt tubes |
| Set by Flow1D model |
| Integer | Nf (from DistributedHeatTransferFV) | 2 | Number of nodes on the fluid side |
| Integer | Nw (from DistributedHeatTransferFV) | Nf - 1 | Number of volumes on the wall side |
| Integer | Nt (from DistributedHeatTransferFV) | | Number of tubes in parallel |
| SI.Distance | L (from DistributedHeatTransferFV) | | Tube length |
| SI.Area | A (from DistributedHeatTransferFV) | | Cross-sectional area (single tube) |
| SI.Length | omega (from DistributedHeatTransferFV) | | Wet perimeter of heat transfer surface (single tube) |
| SI.Length | Dhyd (from DistributedHeatTransferFV) | | Hydraulic Diameter (single tube) |
| SI.MassFlowRate | wnom (from DistributedHeatTransferFV) | | Nominal mass flow rate (single tube) |
