modelAirToWater
Extends from Buildings.Templates.Components.BaseClasses.PartialHeatPumpTableData2DLoadDep.
Information
This is a model for an air-to-water heat pump where the capacity
and input power are computed by interpolating manufacturer data
along the condenser entering or leaving temperature, the
evaporator entering or leaving temperature and the part load ratio.
The model can be configured to represent either a non-reversible
(heating-only) heat pump (is_rev=false) or a
reversible heat pump (is_rev=true).
This model is a wrapper for Buildings.Fluid.HeatPumps.ModularReversible.TableData2DLoadDep, which the user may refer to for the modeling assumptions. Note that, by default, internal safeties in this model are disabled.
Control points
Refer to the documentation of the base class Buildings.Templates.Components.BaseClasses.PartialHeatPumpTableData2DLoadDep for a description of the available control input and output variables.
Components
| Type | Name | Default | Description |
|---|---|---|---|
| Buildings.Controls.OBC.CDL.Reals.MultiplyByParameter | mAir_flow | Air mass flow rate | |
| Buildings.Controls.OBC.CDL.Conversions.BooleanToReal | y1Rea | Convert on/off command into real | |
| Fluid.Movers.BaseClasses.IdealSource | floSou | Air flow source |
Revisions
-
August 21, 2025, by Antoine Gautier:
Refactored with load-dependent 2D table data heat pump model.
This is for #4152. -
March 29, 2024, by Antoine Gautier:
First implementation.